数控排钻中心操作注意事项_行业知识_新闻资讯_青岛大荣伟业数控科技有限公司

更多 > 新闻资讯

行业知识

数控排钻中心操作注意事项

数控排钻中心操作注意事项：
Nc drilling center operating considerations:
数控排钻中心的设备操作前，请详细阅读说明书。数控排钻
Nc drilling center before operation of the device, please read the instructions in detail.
检查接地线是否接地牢固，各部件是否正常，操作位置是否光线明亮，（未经培训的人员不要操作本机床），而且在操作时要做到三紧、三不、一注意。
Check whether the ground wire is grounded firmly, all parts are normal, operating location whether bright light, (untrained personnel do not operate the machine), and the operation to do three, three, a note.
三紧是：衣着紧身、紧腰、紧袖。
Three is: tight dress is tight, tight waist and sleeve.
三不是：不系领带、不戴手饰、不带手套；
Sometimes is: don't tie, don't wear a bracelet, with no gloves;
一注意：注意保护眼睛。启动机床前，请注意所有警告标志的指示。
A note: pay attention to protect his eyes. Please note that all warning signs before start the machine instructions.
弄清钻头的旋转方向，正确选用钻头，数控排钻中心操作时不得靠近或触摸移动或转动零部件。
Find out the direction of rotation of drill bit, correct choose bit, CNC drilling operation shall not be close to or touching moving or rotating parts.
本文由数控排钻友情奉献.更多有关的知识请点击:http://www.qddrsk.com/我们将用的技术.真诚的态度.为您提供为的服务.更多有关的知识我们将会陆续向大家奉献.敬请期待.